KUDOS ULTIMATE 1 Series Installation Instructions Manual
chemicals or aerosol products - these may result in damage to the surfaces.
See instruction below for glass cleaning advice.
LIFE SHIELD
Your Kudos product is treated with Life Shield on the inside and
outside surface. Though this helps prevent the build up of lime-
scale and soap deposits, the glass still needs regular
maintenance. We recommend the use of a detergent and aroma
free glass cleaner (A 50/50 mix of vinegar and water works well)
Strong detergents and abrasives can damage the coating.
After showering use a squeegee to remove droplets of water from
THESE INSTRUCTIONS ARE TO BE LEFT WITH THE CONSUMER
1000 / 1200
FRONT PANEL COMPONENT KIT
1500 & 1700
SHOWER TRAYS
SHOWER TOWER
800 / 900 / 1000
SIDE PANEL COMPONENT KIT
Related Manuals for KUDOS ULTIMATE 1 Series
Bathscreen (6 pages)
Straight sliding door 1400 & 1500mm (5 pages)
Hinged door (7 pages)
Pivot wide door (5 pages)
Summary of Contents for KUDOS ULTIMATE 1 Series
- Page 1 LIFE SHIELD NB- Please ensure that the ceiling entry point for this Your Kudos product is treated with Life Shield on the inside and supply is clear of any structural framework. outside surface. Though this helps prevent the build up of lime-.
- Page 2 SHOWER CONTROL POSITION Run data cable to recommended position as shown NOTE: ALL DIMENSIONS ARE Recommended position Recommended position for data cable outlet FROM BASE OF for data cable outlet TRAY TO CENTRE OF HOLES (UNLESS STATED OTHERWISE) Overall height of shower tray = Outlet hole for Outlet hole for 55mm.
- Page 3 TILING ALLOWANCE To overcome the width of the integral upstand of the shower tray, either method can be used IMPORTANT: IF THE DIMENSIONS SHOWN ARE EXCEEDED THEN THE GLASS PANEL(s) WILL NOT FIT MUST NOT EXCEED 15mm MUST NOT EXCEED 15mm TILED SURFACE MUST NOT BE LESS THAN 878mm (1500 tray)
- Page 4 FRONT GLASS PANEL FIT FRONT GLASS PANEL Remove aluminium wallpost from front glass panel and Insert finial bottom assembly (with inner cover set aside glazing seal for later use removed) into location bush. With assistance, carefully insert glass panel into wallpost and onto finial body.
- Page 5 FIX RAIL WALL BRACKET FIT FINIAL TOP(s) Re-position wall bracket to wall and mark through Fit finial top assembly through hole at top edge of fixing hole. Drill (8mm), plug and fix using No.12’s x glass panel using 4mm Allen key supplied, ensuring 30mm long screw provided.
- Page 6 FIT SHOWER TOWER SYSTEM Ensure all component parts are fitted to the relevant tubes before securing to front glass panel. UNDER-TRAY OVERHEAD WATER SUPPLY WATER SUPPLY UNDER-TRAY WATER SUPPLY Fit plug connector to TOP of Water Outlet Body, ensuring the rubber washer is fitted. Feed flexible hose through 945mm long bottom tube and connect to BOTTOM of Water Outlet Body, ensuring rubber washer is fitted.